Adding bathroom, kitchen or laundry facilities can be impossible if sewer
or waste lines cannot receive drainage by normal gravity fall methods.

LOMAC provides an ideal, practical solution with a range of pumps that discharge efficiently up to 6metres vertically, 70 metres horizontally (1:200 fall) or a lesser combination of both. All operate on a standard 230/240 volt power supply.
When a toilet is flushed or a tap run, the LOMAC
pump activates automatically, discharging waste
through a space saving 25mm pipe to the sewer.
       

Easy and economical to install without major disruption to building and occupants, LOMAC pumps are designed to run quietly and without odour.
Many years’ experience in the European market has resulted in a precision engineered system utilising heavy duty components for trouble free service.
Each LOMAC pump carries a full two year warranty.

Greywater Tea Room Pump (modified)
Pump is modified (top inlet only) to handle sink drainage from hot water units attached to tea room facilities.
Accepts short bursts in excess of the maximum 60 degree C normal operating temperature.
   

Greywater Pump
Purpose designed to pump waste water from sinks, tubs, dishwashers and washing machines, pump is also ideal for washrooms with no toilet.
Features a push fit top inlet for sink waste as well as two side inlets.
   

Bathroom Pump
The powerful Bathroom Pump enables installation of a combination of bathroom facilities – toilet, bidet, vanity, shower and bath.
The side inlets are located low in the base to allow easy drainage into the unit with minimum fall.
   

Toilet Pump
Designed to cater for toilet, vanity or wash basin waste.
Seen as the perfect solution to renovating problems, the toilet and bathroom pumps are both equipped with stainless steel cutters that are safe andself cleaning.
   
LOMAC pumps are extremely versatile, having the ability to solve a wide range of drainage
problems. The 25mm pump out line (shown in red below) can be routed almost anywhere from
the facility to the sewer.
The chart below shows that the units are powerful and clever enough in design to allow
pumping up to 6m in height, 70m horizontally (1:200 fall) or a lesser combination of both.
   

Pumping Combinations

Applications

   
Bathroom & Greywater Pump Dimensions
Dimensions are identical for both Bathroom and Greywater pump models. (Not to scale)
Greywater pump does not have toilet pan inlet facility.
 
Toilet Pump Dimensions  
LOMAC pumps are fully approved/certified in full compliance with all Australian, New Zealand and European standards appropriate to plumbing and electrical requirements.
Distribution is through the AS/NZ 9001 quality endorsed INSAPIPE INDUSTRIES LTD

Australia
 Tel + 61 3 9543 7500
Fax + 61 3 9543 8535
Email: sales@insapipe.com

New Zealand
Tel + 64 9 273 3703
Fax + 64 9 273 3704
Website: www.insapipe.com

All information in this brochure is a guide only and no responsibility will be accepted for any errors, omissions or misinterpretations.
Full details are in the installation instructions available on request and with each pump.
LOMAC Information:
Brochure
Grey Water Pump Installation Instructions
Bathroom Pump Installation Instructions
Toilet Pump Installation Instructions
FAQ

© 2003 Insapipe Industries Ltd. All rights reserved